Diamonds & Dyes

Diamonds

A variety of high-quality diamond tools to effectively grind and hone concrete floor surfaces.

BENEFITS & ADVANTAGES

  • Densified Floor Surface
  • Dustproof
  • Increased Abrasion Resistance
  • Increased Floor Hardness
  • LEED Qualified
  • Lowest Life Cycle Cost
  • Marble-Like Shine / Increased Light Reflectivity
  • Reduced Maintenance
  • Unlimited Decorative Combinations

Contact your local sales representative to get your product!

 

RetroPlate®

RetroPlate®

Concrete is tough, right?  So why is the RetroPlate System necessary?

Concrete in its natural state is a porous product that is susceptible to efflorescence, spalling and dusting. It does not provide an aesthetic finish, nor is it easily maintained. That’s why Curecrete actually created the science and art which converts boring concrete to one of strength, longevity, and beauty.

BENEFITS & ADVANTAGES

  • Densified Floor Surface
  • Dustproof
  • Increased Abrasion Resistance
  • Increased Floor Hardness
  • LEED Qualified
  • Lowest Life Cycle Cost
  • Marble-Like Shine / Increased Light Reflectivity
  • Reduced Maintenance
  • Unlimited Decorative Combinations

Contact your local sales representative to get your product!

 

Ashford Formula™

Ashford Formula™

The Ashford Formula densifies with a unique and unmatched catalytic chemistry. Nearly 70 years ago, the Ashford Formula was developed as an alternative to coatings. When this product first came on the market, there were many skeptics who could not believe that one product could permanently make floor surfaces resistant to abrasion, easy to clean and free of dust.

Almost seven decades of performance have proven them wrong. These permanent results are achieved through the unique and unmatched catalytic chemistry. The concept is very simple: a concrete floor surface is internally densified through a process of crystalline growth. The same reaction also hardens the concrete and locks up the dust. Because the chemistry is inorganic, there is nothing to wear out, scratch or peel.

BENEFITS & ADVANTAGES

  • Densified floor Surface
  • Dustproof
  • Increased abrasion resistance
  • Increased floor hardness
  • LEED qualified
  • Lowest life cycle cost
  • Marble-like shine / increased light reflectivity
  • Reduced maintenance

Contact your local sales representative to get your product!

 

RetroGuard™

RetroGuard™

RetroGuard™ provides ultimate stain and etch protection with a high gloss finish. This topical coating is ideal for protecting concrete and terrazzo against staining. When a spill occurs, RetroGuard’s layer of protective properties prevent the floor from immediate damage and increases the window of opportunity for clean-up.

BENEFITS & ADVANTAGES

  • Ultimate stain and etch protection
  • Topical sealer
  • Strong floor adhesion; does not peel or flak
  • Creates high gloss and shine when burnished; cures without burnishing
  • Enhances floor color including dyes and aggregate
  • UV stable; may be used outdoors
  • Can be re-applied anytime; does not require stripping
  • Creates sacrificial layer between spill and floor
  • Reduces expensive and time consuming stain repair
  • Ideal for all Ashford Formula and RetroPlate treated floors – new or old, standard or colored – and all concrete and terrazzo floors

Contact your local sales representative to get your product!

 

RetroPel™

RetroPel™

RetroPel™ is an oil and water repellent specifically formulated for concrete and terrazzo floors. It prevents oil from penetrating the floor and water reactions that cause whiting.

Newly densified and polished floors remain susceptible to water and oil penetration because the densification process (which aids in mitigating stains) hasn’t been fully achieved. The majority of this process is achieved within the first 48 hours, but continues for up to 6 months. RetroPel provides repellency during this critical phase.

RetroPel has been formulated with advanced, water-based fluoropolymers. These small molecular structures allow for maximum penetration. It is not a topical sealer, but rather, a penetrating sealer that fills the microscopic gaps in the floor’s crystalline structure. It does not change the appearance of the floor.

BENEFITS & ADVANTAGES

 

  • Penetrating sealer that fills microscopic gaps in the floor
  • Protects newly densified and polished floors from water
  • reactions that cause whiting
  • Does not affect the appearance of the floor
  • Easy, stress-free application; less applicator fatigue
  • Does not require burnishing to cure
  • Ideal for all Ashford Formula and RetroPlate treated floors – new or old, standard or colored – and all concrete and terrazzo

Contact your local sales representative to get your product!

 

CreteClean Plus with Scar Guard™

Creteclean Plus with Scar Guard™

CreteClean Plus with Scar Guard™ is designed to clean and maintain concrete floors and is specifically formulated to clean densified and densified-polished concrete, a big plus since most cleaners can actually be harmful to concrete surfaces.  For the first time ever, your concrete floor can be enhanced at the same time it is being cleaned.  Unique proprietary ingredients, combined with cutting-edge Scar Guard technology, over time, can improve the performance of your concrete floor.  

BENEFITS & ADVANTAGES

  • Specifically Formulated to Clean Concrete Floors
  • Chemically Attracts and Suspends Grit and Oil
  • Rinse Free!
  • Allows Natural Sheen to Come Through
  • Heals Minor Scratches and Scrapes
  • Used as a Poultice, Removes Tough Oil Stains
  • Saves Valuable Time and Money
  • Extend Your Warranty
  • Reduced Environmental Impact

Contact your local sales representative to get your product!

 

CreteClean Plus with Scar Guard – Single Dose™

Creteclean Plus with Scar Guard - Single Dose™

CreteClean Plus with Scar Guard – Single Dose™ makes cleaning your floors convenient and easy. No measuring, no guessing. Simply empty the contents of any single-dose container into the appropriate size cleaning tank or bucket, add fresh water, and you’re ready to start cleaning!

BENEFITS & ADVANTAGES

  • No guesswork
  • Eliminates any possibility of over or under dosing
  • Track costs, inventory and usage easier
  • No multiple packages per tank
  • Uniformity regardless of operator changes

Contact your local sales representative to get your product!

 

CreteFill Pro Polyurea Pump™

CreteFill Pro Polyurea Pump™

The CreteFill Pro Polyurea Pump™ is the optimal pump designed specifically for high efficiency and quality workmanship with the CreteFill Pro Series line of joint fillers and repair products.  It is one-man operational, easy-to-clean, has adjustable flow volumes, is lightweight and built to last.

The CreteFill Pump GC-13 has a combined capacity of 13 gallons and is ideal for a 10-gal kit of CreteFill Pro 85 Joint Filler, Crack Repair EZ Shave, and Spall Repair.

 

Contact your local sales representative to get your product!

 

SaltSlayer™

SaltSlayer™

SaltSlayer™ is a silane that provides salt and water repellency to concrete and masonry. Silane reacts with the silica in concrete, and is therefore ideal for use on concrete floors which require additional repellency against salt-bearing water.

BENEFITS & ADVANTAGES

  • Complete water and salt repellency
  • Easy to use; single pass spray application
  • Minimal masking, overspray or clean-up required
  • No change in texture or skid resistance
  • Does not alter the appearance of the application surface
  • Penetrating sealer
  • Fast acting; floors open to traffic within 20-45 minutes following treatment
  • Low susceptibility to UV light
  • Helps stop efflorescence
  • Compatible with solvent-based surface treatments (i.e. striping paint)
  • Does not affect vapor permeability
  • Ideal for all Ashford Formula™ and RetroPlate® treated floors – new or old, standard or colored – and all concrete and terrazzo floors

IDEAL USES

  • Bus Garages
  • Parking Decks
  • Car Service Bays

Contact your local sales representative to get your product!

 

CreteFill Crack Repair EZ Shave™

CreteFill Crack Repair EZ Shave™

CreteFill Crack Repair EZ Shave™ is designed for rapidly and structurally filling cracks in concrete. It offers slight flexibility for ease of shaving. 

 

IDEAL USES

 

  • Filling and repairing spalls before applying coatings
  • Filling cracks in concrete on parking decks
  • Floor repair
  • Knitting cracked slabs
  • Traffic-area spalls and crack repairs
  • Stopping additional damage

 

Contact your local sales representative to get your product!

 

CreteFill Spall Repair™

CreteFill Spall Repair™

CreteFill Spall Repair™ is designed to repair damaged control joints, large cracks, and spalls where no future slab movement is expected. When combined with sand, CreteFill Spall Repair will develop into an extremely strong polymer concrete.

IDEAL USES

  • Delaminated concrete slabs
  • Filling and repairing spalls before applying coatings
  • Freezer threshold repair
  • Grade matching
  • Parking deck repair
  • Repairing deteriorated concrete
  • Replacing lost concrete sections
  • Spall repairs

Contact your local sales representative to get your product!

CreteFill Pro 85™

CreteFill Pro 85™

CreteFill Pro 85™ is used to fill control joints (new or damaged) and random cracks on horizontal concrete. It is slightly flexible, allowing small slab movement, yet strong enough to protect the vertical edges of concrete from chipping under extreme loading. CreteFill Pro 85 is tack free in 10-12 minutes.

IDEAL USES

  • Airports
  • Bottling and canning facilities.
  • Food processing facilities.
  • Freezers and cold storage.
  • Industrial and warehouse floors.
  • Manufacturing facilities.
  • Parking garage decks.
  • Pulp and paper mills.
  • Wastewater treatment plants

Contact your local sales representative to get your product!

 

KickStart™

KickStart™

KickStart Clarity Enhancer is a unique liquid formulation that provides accelerated and enhanced clarity to hard steel troweled concrete in fewer grinding/polishing steps. In conjunction with CreteClean Plus with Scar Guard Single Dose, KickStart produces enhanced clarity at any finish, whether cream, salt ‘n pepper or exposed aggregate.

BENEFITS & ADVANTAGES

  • Accelerated, enhanced clarity in fewer grinding/polishing steps
  • Achieve higher clarity with lower grit diamonds
  • Increased diamond performance as a result of enhanced lubricated environment/slurry
  • Easy to clean slurry from diamonds and floor
  • Can be used on Ashford Formula and RetroPlate floors and in conjunction with all Curecrete supporting products
  • Suitable for new or existing concrete; concrete restoration
  • Single component solution
LOWER LABOR EQUIPMENT COSTS – HIGHER PROFITS

The KickStart process provides applicators/contractors with the ability to increase efficiency, save on labor and equipment costs, and ultimately increase profits.

Increased Efficiency, Better Results

  • Does not require the floor to be pre-wet overnight
  • Fewer steps than traditional grinding method; allows for quicker progression from metals to hybrids to resins
  • Better performing diamonds as a result of better-lubricated environment

Significant Labor and Equipment Cost Savings

  • Fewer steps, fewer man hours on the job site
  • Fewer steps, and fewer diamond tools needed
  • Less operator fatigue due to an enhanced lubricated environment

Higher Profits

  • Accomplish more work in less time, without the need to hire more labor or purchase more equipment or tools

Contact your local sales representative to get your product!

 

CreteStrip™

CreteStrip™

CreteStrip™ is a chemical stripper designed to effectively dissolve and remove substances and contaminants from concrete and terrazzo surfaces.  CreteStrip is effective in removing construction chalk, spray adhesive, waxes, tire marks, tape residue and more!  It even substantially lightens oil and grease stains.

BENEFITS & ADVANTAGES

  • Easy to apply
  • Works fast – works in 30 minutes
  • Requires little scrubbing – works chemically

IDEAL USES (FOR REMOVAL)

  • Acrylic floor coats
  • Carpet & tile mastic
  • Construction chalk
  • Oil & grease stains
  • Tire Marks
  • Waxes

Contact your local sales representative to get your product!

 

CreteStrip FS™

CreteStrip FS™

CreteStrip FS™ is a concentrated stripper formulated to give concrete floors a fresh start in preparation for densification or restoration. CreteStrip FS is designed for concrete and terrazzo floors, aiding in the quick and effective removal of acrylic floor coatings, acrylic curing compounds, waxes, carpet and tile mastic, paint, tire marks, and more!

BENEFITS & ADVANTAGES

  • Short dwell time:
    Floor Finishes: Effective within 5 minutes
    Guard Products: Effective within 1 minute
  • Mild frangrance
  • Low-foaming
  • Low VOCs
  • Cost effective
  • Does not damage vinyl
  • Does not contain ammonia
  • Does not soften concrete

IDEAL USES (FOR REMOVAL)

  • Acrylic floor coats
  • Carpet & tile mastic
  • Construction chalk
  • Oil & grease stains
  • Tire Marks
  • Waxes

Contact your local sales representative to get your product!

 

Go to Curecrete Connect